POWER IN THE GROUND.

GAS & UNDERGROUND ELECTRICAL CONTRACTOR

Gas and power infrastructure built to utility spec, with every existing line found before we dig.

GAS AND POWER LEAVE NO ROOM FOR “CLOSE ENOUGH.”

We locate, pothole and hand dig in the tolerance zone, build to the utility’s standards, and have it ready for inspection the first time. Fast is good. Fast and right is the job.

FROM TRENCH TO TRANSFORMER

GAS LINES

Mains and service lines installed to gas utility standards

UNDERGROUND POWER

Conduit, wiring and connections under one contract

DUCT BANKS

Encased conduit runs for power and communications

JOINT TRENCH

Gas, power and fiber in one trench, sequenced and separated to spec

PADS & VAULTS

Transformer pads, switchgear pads and pull vaults

STREETLIGHTS

Conduit, pull boxes and light bases

LOCATES & POTHOLING

Every existing utility exposed and marked before excavation

UTILITY RELOCATIONS

Moving existing gas and power lines out of the way of new construction

WE TREAT EVERY LINE LIKE IT’S LIVE.

Most of what’s underground was put there by someone else, sometimes decades ago, sometimes not where the map says. So we call it in, pothole it, verify it and protect it before any bucket or shovel gets close. It’s slower for about ten minutes and faster for the rest of the job.

HOW A GAS OR POWER JOB RUNS

STEP 1

COORDINATE

Utility design, inspection and outage windows lined up before mobilization.

STEP 2

LOCATE & POTHOLE

Existing lines found and exposed.

STEP 3

INSTALL

Trench, bedding, conduit or pipe and separation built to utility spec.

STEP 4

INSPECT & CLOSE

Utility inspection, backfill, compaction and restoration.

FREQUENTLY ASKED QUESTIONS

NEED A JOINT TRENCH?

Gas, power and fiber in one trench, one contract, one crew.